Building My Motor

A motor is essentially two magnetic fields - one stationary while the other one flips from north to south, which causes the armature to spin. A motor has a few parts: the field magnet, the armature, the brushes, the copper contacts.

Supplies:

• 24 gauge copper magnet wire 
• 14/16 gauge solid lamp wire 
• 14/16 gauge lamp wire 
• Thin copper (for contacts; foil may also be used) 
•  Base plank 
• Steel L brackets (2 large brackets and two small brackets) 
• 1/8 inch diameter metal rod - one long length and two shorter lengths 
• Scrap wood 
• Screws/Nails to attach scrap wood to base and screw in L brackets 

Steps:
1) Build the field magnet: take two L shaped pieces of steel ( steel conducts electricity well) and begin to wrap SOLID lamp wire around it. Five or six layers of wire should create a strong magnet. Be careful to not overlap the wire as this disrupts the magnetic field. The left side of the L will always be the north pole. Attach this to the base. Leave one end of wire free to attach to the battery later and leave one to attach to a brush.

2) Next you will need to create supports for your armature and the brushes. I choose to mount smaller L brackets onto scrap wood to hold the armature and I built a 'house' out of scrap wood with holes on top to push the brushes through.

4) Next take a thin metal rod, approximately 1/8 inch diameter, and tape two nails on either side so that a T shape is formed. Next begin to wrap magnet wire VERY neatly, working from one end of the metal rod to the nail head. Be sure to leave a little extra wire sticking out from the center of the armature. Then come back from the nail head to the rod and cross over to the other side - making sure to keep wrapping in the same direction. Repeat the process on the other side. In order to keep the wire smooth and prevent it from crossing over and disrupting the magnetic field, I chose to put a clear layer of tape in between the first and second layers of magnet wire. This is the armature.

5) Now it is time to create the copper contacts. Take a cork and drill a hole through the center so the metal rod is snug. Using either two pieces of foil or copper and (copper conducts electricity better and is more heavy duty) staple them to the cork. When attaching the two pieces make sure they do not touch - the gap is necessary in order to flip the magnetic field. On the flip side, do not make the gap too large otherwise there will not be enough surface area for the brushes to touch. If you chose to use copper, rub the outsides with steel wool in order to remove any enamel that could disrupt the motor later. Then proceed to scrape of the colored coating from the magnet wire left over from the armature. Tuck the stripped wire underneath the metal on the cork.

6) It is time to attach the brushes. Using two pieces of multi strand lamp wire, strip the wires and push them through the two holes you created in the top of the 'house'. At this point the copper contact should be under the roof of this house so that the brushes can make contact. Fan out the wire once you have pushed it through the holes - you may need to use tape in order to keep the brushes in the proper position. Remember to attach one of the brushes to the solid lamp wire from the field magnet. The second brush will attach to the battery later.

7) Your motor is complete - you just need to attach the circuit you have created to the battery. Attach one end of wire left from the field magnet to your 6 volt battery and attach one of the ends of the brushes to the other coil on your battery. This should complete the circuit and cause the motor to spin. Alligator clips can also be used if you did not save enough extra wire to reach the battery.

Here is the completed motor: 

In conclusion building a motor should be easy. As long as the wire is wrapped well, and the copper is attached and the brushes make contact, the motor will work. However, problems can arise. I will discuss some of the challenges I faced when building my motor in my next post.